Renault
Robot Electric Pump Relay Quickshift Renault Trafic 2
Robot Electric Pump Relay Quickshift Renault Trafic 2
Couldn't load pickup availability
- Estimated delivery for an order placed today: (DPD or DHL)
- New part, 1-year warranty
- Diagnostic assistant by chat, 24/7
NEW relay for the electric pump of the Quickshift automatic gearbox robot: 12 V, 4 pins, with diode. It replaces the original relay. Photo for illustration only: the relay colour may vary, with no effect on operation. 1-year warranty.
Compatibility
Compatibility
Renault Trafic 2, 2005-2014.
Petrol, diesel, Twingo 1: the Quickshift parts compatibility guide.
Common symptoms
Common symptoms
electric pump silent when the ignition is on (no pressure, no gears), electric pump running continuously even with the ignition off (relay stuck), battery draining, electric pump fuse blowing.
Related fault codes
Related fault codes
DF065, DF252
Meaning:
- DF065: pump relay circuit (pressure fault).
Full list: Quickshift fault codes (DF, DTC and P-code).
Confirm the diagnosis
Confirm the diagnosis
- You can drive and the gears engage? The electric pump works: look at the accumulator instead.
- Direct test: power the electric pump with 12 V directly from the battery, using 2 wires. If it does not run, its motor is dead.
- It runs, then stops: the pressure builds up, it works. With a diagnostic tool, it should start at around 40 bar and stop at around 50 bar.
- It runs without ever stopping: either it no longer builds up pressure, or its control relay is stuck (code DF065, pump relay circuit).
- It runs on the battery but never switches on in the car: the control relay or the pressure sensor is at fault. A diagnostic tool that reads the pressure will tell you which.
Guide with video: diagnose the gearbox in 8 seconds.
Manufacturer references
Manufacturer references
7700810936, 7700810396, 6001545533
Step-by-step fitting
Step-by-step fitting
Supplied complete with its pump: the electric pump fits directly, with no part to transfer from the old one.
Tools: 10 mm socket, 13 mm open-ended spanner, Torx T30, large syringe, drip tray.
- Empty the reservoir with the syringe and place the drip tray under the electric pump.
- Depending on the vehicle, remove the driver's side headlight (10 mm socket): the electric pump comes out more easily that way.
- Loosen the rigid pipe nut (13 mm spanner) and unplug the connector.
- Remove the 2 upper T30 screws, then lever at the top with a large screwdriver to free the lower fixing. Take the assembly out.
- Fit the new electric pump, refit the upper screws, tighten the pipe with the 13 mm spanner and plug the connector back in.
- Oil level, cold: 38 mm above the reservoir joint. With the ignition on, it drops to the joint.
No bleeding or reprogramming: the air bubbles rise by themselves the first time the ignition is switched on.
Guide with video: fitting the electric pump.
Replacement tips
Replacement tips
If the electric pump keeps running after the key is removed, the relay is stuck: replace it without delay: the pump overheats and drains the battery. If it no longer starts when the ignition is switched on, check the fuse first, then the relay.
Guides: electric pump running constantly · the electric pump fuse blows
Shipping, 1-year warranty and returns
Shipping, 1-year warranty and returns
Estimated delivery for an order placed today: , by DPD or DHL, 2-4 working days after dispatch from France. On working days, order before 1 pm (Paris time) for dispatch on the next working day.
Shipping costs: €18.24 to France; €30.41 with DPD or €32.44 with DHL to the other European countries we deliver to.
1-year warranty: all our new parts have a 1-year warranty. Keep your invoice.
Withdrawal: you have 14 days from receipt to return an unfitted part to us, in its original condition. The cost of this return is at your expense. The refund is made within 10 days of receiving the part.
• DHL

Contact us
-
LeverAndCo
Rue du Nauron
79180 Chauray, France
No collection on site -
Chat
Via the chat at the bottom right
QUICK REPLY -