Renault
Electric Pump Easytronic Opel Combo D
Electric Pump Easytronic Opel Combo D
Couldn't load pickup availability
Frequently bought together
Could not add to cart. Please try again.
🚚 Estimated delivery:
- Estimated delivery for an order placed today: (DPD or DHL)
- New part, 1-year warranty
- Diagnostic assistant by chat, 24/7
New complete electric pump (motor and pump) for the Easytronic gearbox robot of the Opel Combo D. It pressurises the hydraulic circuit.
Compatibility
Compatibility
Opel Combo D.
Petrol, diesel, Twingo 1: the Quickshift parts compatibility guide.
Common symptoms
Common symptoms
noisy electric pump that no longer starts or no longer stops, pressure building up too slowly, hydraulic pressure fault, gearbox in limp mode.
Confirm the diagnosis
Confirm the diagnosis
- You can drive and the gears engage? The electric pump works: look at the accumulator instead.
- Direct test: power the electric pump with 12 V directly from the battery, using 2 wires. If it does not run, its motor is dead.
- It runs, then stops: the pressure builds up, it works. With a diagnostic tool, it should start at around 40 bar and stop at around 50 bar.
- It runs without ever stopping: either it no longer builds up pressure, or its control relay is stuck (code DF065, pump relay circuit).
- It runs on the battery but never switches on in the car: the control relay or the pressure sensor is at fault. A diagnostic tool that reads the pressure will tell you which.
Guide with video: diagnose the gearbox in 8 seconds.
Manufacturer references
Manufacturer references
95512366.
Step-by-step fitting
Step-by-step fitting
Supplied complete with its pump: the electric pump fits directly, with no part to transfer from the old one.
Tools: 10 mm socket, 13 mm open-ended spanner, Torx T30, large syringe, drip tray.
- Empty the reservoir with the syringe and place the drip tray under the electric pump.
- Depending on the vehicle, remove the driver's side headlight (10 mm socket): the electric pump comes out more easily that way.
- Loosen the rigid pipe nut (13 mm spanner) and unplug the connector.
- Remove the 2 upper T30 screws, then lever at the top with a large screwdriver to free the lower fixing. Take the assembly out.
- Fit the new electric pump, refit the upper screws, tighten the pipe with the 13 mm spanner and plug the connector back in.
- Oil level, cold: 38 mm above the reservoir joint. With the ignition on, it drops to the joint.
No bleeding or reprogramming: the air bubbles rise by themselves the first time the ignition is switched on.
Guide with video: fitting the electric pump.
Replacement tips
Replacement tips
We recommend replacing the pressure accumulator at the same time: both parts wear at the same rate.
Shipping, 1-year warranty and returns
Shipping, 1-year warranty and returns
Estimated delivery for an order placed today: , by DPD or DHL, 2-4 working days after dispatch from France. On working days, order before 1 pm (Paris time) for dispatch on the next working day.
Shipping costs: €18.24 to France; €30.41 with DPD or €32.44 with DHL to the other European countries we deliver to.
1-year warranty: all our new parts have a 1-year warranty. Keep your invoice.
Withdrawal: you have 14 days from receipt to return an unfitted part to us, in its original condition. The cost of this return is at your expense. The refund is made within 10 days of receiving the part.
• DHL

Contact us
-
LeverAndCo
Rue du Nauron
79180 Chauray, France
No collection on site -
Chat
Via the chat at the bottom right
QUICK REPLY -